Trend H/JIG/A Hinge Jig two part in case
A two-part aluminium hinge jig portable template set designed for recessing hinges in wooden doors & frames.
It is easy to use with minimal setting-up time, completing the job both accurately & quickly.
Used on-site & in joinery shops to increase productivity with excellent results.
Four apertures for fire door requirements.
No need for marking out in the conventional way.
Quick & simple to set-up as the hinge is used as the pattern.
Clean & accurate recesses are achieved every time. Suitable for timber based doors & square butt hinges.
Use with a light duty plunge router with 1/4 inch collet.
Long reach router cutter required, 12mm diameter with 70mm overall lng..
Angled position slots to prevent creep.
Unibase may be needed.
Patent No. GB2285410.
T4EK router requires a ref. UNIBASE or special guide bush ref. GB/T4/160.
Hinge sizes possible
lng. min.=2 5/8" (67 mm)
lng. max.=5" (127 mm)
Width min.=3/8" (9.5 mm)
Width max.=1 3/8" (35 mm)
Door sizes possible
Height min.=6' 5" (1955 mm)
Height max.=6' 10" (2100 mm)*
Thickness min.=5/8" (16 mm)
* Please note for doors over 2040mm the bottom hinge will be higher than 9" up.